IGNITION ADVANCER FITTING

[ninja boy]

Has any 1 fitted a 4 degree advancer to their F2P...???....

do i need any special tools or a straight forward job ???

...any help most appreciated...

[Gobert]

I have - no special tools required.

[ninja boy]

does it have engine oil covering it ?...or is it just a simple swap over ?

[sarge2771]

no mate , no oil, just a simple swap over 20 mins to fit approx from start to finish
you wont regret it

[ninja boy]

i'll get cracking on it tomorrow then......am all fingers and thumbs so might take me a couple of hours.... ...

will make sure i dont forget my screwdriver and trusty hammer......

[ninja boy]

oooohhhh.....i forgot....do i need tools...???....and gasket paste or anything i might come across ?

[chance]

nope, no special tools needed and no gaskets that need replacing
tis a n easy job

[ninja boy]

well now that sounds hopefully easy enough for even me.....thanks for the info guys..

[sarge2771]

look in the how to guides
-- n/a
there you go mate hope this helps
where in north east are you???
im in hull

[ninja boy]

thanks for that sarge.....but it doesn't say which way the nut comes off...anti-clockwise or clockwise...

[sarge2771]

thanks for that sarge.....but it doesn't say which way the nut comes off...anti-clockwise or clockwise...

no probs
If i remember rightly its anti clock wise

[ninja boy]

OKEY DOKEY SARGE......WILL CRACK ON TOMORROW WITH IT.....TA ONCE AGAIN M8

[ninja boy]

got it fitted,,,,,oh how easy was that....!!!....soooo easy.....thought i'd knacked the rubber gasket but luckily NOT....just need to see if i can notice any difference when the weather is ok,.....

[conkerman]

Will fitting one of these mean I will have to use super unleaded if I want to avoid pinking??

Conks

[ninja boy]

alrite conks....since fitting the advancer i've had no pinking or anything m8