WHOSE FITTED A SCORPION EXHAUST TO THERE F1/F2 ???

ninja boy · Post by **ninja boy** » 08 Feb 2008, 17:49

JUST BOUGHT A SCORPION END CAN WITH THE LINK PIPE...........PROBLEM IS THE LINK PIPE END THAT GOES ON THE DOWNPIPE ONLY JUST FITS OVER IT.....THE ORIGINAL KWAKA 1 IS ABOUT HALF AN INCH BIGGER WITH A CARBON OR SUMMIT GASKET IN IT.......

HAVE THEY GAVE ME THE WRONG LINK PIPE OR DO I DO AWAY WITH THE GASKET THING...?????

hey9r · Post by **hey9r** » 08 Feb 2008, 19:59

Sorry seen Question now

Its a tight fit m8 no gasket required.
You can/could spread/smear a bit of exhaust jointing compound on the male part before you fit it though but I didn't and have no problems.

Hope that helps.

ninja boy · Post by **ninja boy** » 08 Feb 2008, 20:03

cheers for the help m8 i was panicking in case it was the wrong linkpipe, don't want it leaking or causing any damage......strange how they don't make it big enough for the gasket.....

hey9r · Post by **hey9r** » 08 Feb 2008, 20:46

Shouldn't need a gasket as it fits over the pipe not like the Es that fit in to the manifold.

So the gas/fumes flow straight through.

ninja boy · Post by **ninja boy** » 08 Feb 2008, 21:56

thanks once again for your help m8.....

ZX-9R.Net

WHOSE FITTED A SCORPION EXHAUST TO THERE F1/F2 ???

WHOSE FITTED A SCORPION EXHAUST TO THERE F1/F2 ???

Re: WHOSE FITTED A SCORPION EXHAUST TO THERE F1/F2 ???

Re: WHOSE FITTED A SCORPION EXHAUST TO THERE F1/F2 ???

Re: WHOSE FITTED A SCORPION EXHAUST TO THERE F1/F2 ???

Re: WHOSE FITTED A SCORPION EXHAUST TO THERE F1/F2 ???