Exhaust help ...again

[ChrisR]

Hello all ... I hope there is enough people awake to help me with this as the auction ends in 2 hours

Iv got a B1 Model but the exhaust system has been modified and is now about 65mm bore.

I was told that the later cans may fit mine with a little persuasion.

Iv seen this one on Ebay which will match my bike brilliantly but it has a 3 bolt fixing which iv never seen before,iv asked the seller for a pic off the inlet off the exhaust pipe but he must b asleep

Has any one got a pic off what the inlet to this pipe (3 bolt fitting) so i can see what it looks like.

Or does any 1 know if it will be possible to adapt this to a 65mm link pipe?

http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... 3DWatching

Cheers every 1 and happy day

[889R]

Hi ,,ive read somewhare on here that they are not the same on my e1 i can measure the hole and the three fixing bolts be back in amo .

[889R]

The hole for the pipe to go in is 60 mm or 2and 3 10 of an inch across the three bolt holes ar three inches across from the centres of the bolts

[ChrisR]

Cheers for that mate ... hmmmmmmm that may be to small

[Steve-TC1]

This is for a c model , the link pipe is part of the system but the actual can fitting is the same as es http://www.ronayers.com/fiche/400_0437/ ... rent=13770

[ChrisR]

Bloody missed it thanks any way guys

[Steve-TC1]

Thank god for that , it was crap anyhow

[ChrisR]

Thank god for that , it was crap anyhow

I liked the purple to match my screen,headlight and tax disk holder

Was it the colour you didn't like or the actual exhaust?

[Steve-TC1]

Colour =

[ChrisR]

[hey9r]

Colour =

[Alex]

Colour =

When i bought my last 9, it had a red, anodised, carbon can company can on it, it was F***ing awfull.